Turkey's Largest Projector Lamp Sales Platform
TR EN

How to Remove and Install a Projector Lamp

On most projectors a lamp module is replaced in about 15 minutes once the lamp has cooled, with a single Phillips screwdriver. Watch the animation, follow the steps and finally reset the lamp hours for your brand.

Lamp replacement
1Step 1 / 6Switch off and let it cool
Step by step

Tip: wear the supplied gloves or use a cloth; fingerprints shorten lamp life. If you prefer, we fit the lamp free of charge in our workshop.

What you need

  • The correct lamp module for your projector model (check the lamp code on the old lamp or in the manual)
  • A Phillips screwdriver (some models use a flat or Torx screwdriver)
  • Cotton gloves or a clean lint-free cloth
  • A flat, stable surface; for ceiling mounts a safe ladder

Removing the old lamp

  1. Switch off and let it cool. Turn the projector off with the remote, wait until the fans stop, unplug it and let the lamp cool for at least 30–60 minutes. Manufacturers usually recommend about an hour.
  2. Disconnect all cables. Remove the power cord and the signal cables (HDMI, VGA). For a ceiling mount, take the projector down if the lamp cover is on top.
  3. Open the lamp cover. Find the cover (usually on the top, side or bottom, often marked with a lamp symbol). Loosen its screw and slide or lift it off.
  4. Loosen the module screws. The module is usually held by two or three captive screws. They do not come out completely; loosen them until they turn freely.
  5. Pull the module out by its handle. Lift the wire handle and pull the module straight out. Do not tilt it and do not touch the glass.

Installing the new lamp

  1. Check the code. Compare the lamp code on the new module with the old one.
  2. Slide it in. Hold the module by its housing, align it with the guides and push it in until it seats fully. Do not force it.
  3. Tighten the screws and close the cover. Tighten the module screws evenly and refit the cover. Most projectors will not start if the cover is not fully closed.
  4. Power on and reset the lamp hours. Follow the steps for your brand below.

Resetting the lamp hours by brand

Typical menu paths. Names differ slightly between models; if unsure, check your manual or ask us. Reset only after fitting a new lamp.

EpsonMenu › Reset › Reset Lamp Hours › Yes
BenQMenu › System Setup: Advanced › Lamp Settings › Reset Lamp Timer › Reset
OptomaMenu › Setup › Lamp Settings › Lamp Reset › Yes (older models: Options › Lamp Settings)
NECMenu › Reset › Clear Lamp Hours
PanasonicMenu › Option (or Setup) › select Lamp Runtime and hold ENTER for about 3 seconds › OK. Some models then need to be switched off and on.
Hitachi / MaxellMenu › Option › Lamp Time › hold RESET for about 3 seconds › Reset
SonyMenu › Setup / Installation › Lamp Timer Reset. Some models use a button combination; see the manual.

Frequently asked questions

I fitted the new lamp but the projector does not turn on. What now?

Make sure the lamp cover is fully closed and its screw tightened; most projectors have a cover safety switch. Check that the module is fully seated and its screws are tight.

I touched the lamp glass. Is that a problem?

Skin oil burns on the hot glass and can shorten lamp life. Wipe gently with a clean lint-free cloth and isopropyl alcohol.

Can I throw away the old lamp?

No. Projector lamps contain a small amount of mercury; take them to an electronic waste collection point.

What if the lamp has burst?

Switch off, unplug and ventilate the room. Do not shake the projector; ask a service before opening the lamp bay. Contact us for a free diagnosis.

Find the right lamp for your projector

Search by projector model or lamp code. Original lamps with a 1 year warranty.